|
Multi-USB Software Driver
130VC-2 Range Software
130VC-2 Range Firmware
130VC-2 Wiring Diagram PDF
130VC-2 Technical Manual PDF
| |
Multi-USB Software Driver |
32 Series Controls Overview
The 32 Series Actuated Pilot Controls for 300 Series Valves consist of a hydraulic pilot subassembly and 130VC-2 Actuator. These controls are factory set to full adjustment range of the subassembly. The 130VC-2 Actuator accepts a 4 - 20 mA remote setpoint and positions spring loaded of hydraulic pilot subassembly as it maintains setpoint of pressure or flow rate. The pilot subassembly automatically is linear between these limit settings.
Click Here for more information.
Software Quick Information
This software and a special USB connector cable are required to communicate between your Windows XP laptop computer and the 130VC-2 Actuator. The software changes electronic range limits corresponding to 4 - 20 mA command input. Usually electronic re-ranging is done only when initially setting up the valve or when servicing the pilot subassembly. Do not use this software for continuous remote valve control.
| |
130VC-2 Range Software File Name: EDriveSetupV219.exe
Version: 2.19
Date Published: 13 Dec. 2005
Language: English
Download Size: approximately 4.8 MB
|
Software Download Instructions
Supported Operating Systems: Windows XP and XP Service Pack 2
- Click the Download 130VC-2 Range Software button to start the download.
- Do one of the following:
- To start the installation immediately, click RUN to run this program from its current location. Highly recommended.
- To copy the download to your computer for installation at a later time, click SAVE to save this program.
- This program will automatically be installed in new e-Drive folder in C: Program Files/Cla-Val folder. A new Cla-Val folder is created in Program Files folder and an icon link is created on Desktop to start program.
Troubleshooting FAQ
Can I make a file ahead of time and download it to 130VC-2 later?
Hardware hookup steps must be completed before program will communicate and change 130VC-2 parameters. Until wiring and power connections are made to the actuator, this program can be opened, but new parameters can not be created or stored or sent to the actuator. Changes to parameters must be done "live" and while control valve is operating.
How do I get the software to work with the actuator?
To set up a link with 130VC-2 Actuator, first install cable driver and then the special USB communications cable. After installing driver and communication cable, the Actuator must be powered for link to work. Follow wiring diagram and hardware hookup instructions. Click HERE to download 130VC-2 Actuator wiring diagram PDF file.
How do I install Special USB Communication Cable?
When 130VC-2 communications cable is installed in your laptop computer USB port for the first time, Windows will search your computer for the cable USB driver. If Windows Plug and Play does not automatically find the driver and connect to actuator, then the cable driver must be set up manually. Windows will take you step-by-step through the manual set up process. The cable USB driver is installed during software download. You will have to browse to the Cla-Val folder created during download where the driver file is located. Driver installation instructions are in 130VC-2 manual. Click HERE to download 130VC-2 Actuator manual PDF file.
What are the default settings for the 130VC-2 actuator?
Factory default setting for 130VC-2 Actuator range parameter is the full pilot spring range scaled to match the 4 to 20 mA Remote Command Input analog signal. Factory default setting for 130VC-2 Actuator rotation speed is 1/6 rpm.
| 
